Installation Guide

PROTECTAPOOL GATE INSTALLATION
1. The gate is installed between two sections of fence.
2. Gate needs to be installed along a straight run of fencing (not around a curve).
3. The gate has been notched for the hinges and can be hung from left or right side,
simply by rotating the gate 180 degrees.
4. Gate should be hung so material is on outside of gate, and gate always swings out.
5. Gate posts are installed per below illustration.
6. First hole for left gate post is the same as last hole for fence pole (Point A)
7. Mark first hole for left gate post (Point B) 5-1/2” from last hole of fence (Point A)
along same line as fence.
8. Mark next hole for right gate post (Point C) 36” from left gate post (Point B).