Installation Guide

ManualsBrandsGLI Pool Products ManualsKitchen4 ft. x 12 ft. Safety Fence for In Ground Pools

(READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING)

THE FOLLOWING TOOLS ARE REQUIRED FOR INSTALLATION:

Tape measure

Utility knife

Chalk line

Rotary hammer drill

Pencil

1/4” Hex head bit

Extension cords

5/8” SDS Plus masonry drill bit

(If using a safety fence drilling guide, an SDS Plus rotary hammer and a 5/8” X 18”

SDS Plus bit must be used)

Template (included)

Scissors

Household glue or pvc cement

Shop Vac

(for cleaning debris out of drilled holes)

INSTALLATION INSTRUCTIONS

IN GROUND REMOVABLE SAFETY FENCE

Summary of content (6 pages)

PAGE 1
IN GROUND REMOVABLE SAFETY FENCE INSTALLATION INSTRUCTIONS (READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING) THE FOLLOWING TOOLS ARE REQUIRED FOR INSTALLATION: Tape measure Utility knife Chalk line Rotary hammer drill Pencil 1/4” Hex head bit Extension cords 5/8” SDS Plus masonry drill bit (If using a safety fence drilling guide, an SDS Plus rotary hammer and a 5/8” X 18” SDS Plus bit must be used) Template (included) Scissors Household glue or pvc cement Shop Vac (for cleaning debris out of drilled holes)
PAGE 2
1. 2. 3. Decide where you want your fence. When installing In-ground Removable Safety Fencing take these guidelines into consideration: • The fence must isolate the pool area from all exits of the house. • All sides of the pool area should be enclosed by either the In-Ground Removable Safety Fencing and/or another permanent barrier such as a block wall, house, wrought irons fence, etc.
PAGE 3
These methods allow for the fence to be pulled tight under tension to 90 degrees. See figures below. 5. Using a shop vac to ensure holes are clean of debris, tap (do not pound) plastic deck sleeves in the holes and install the first panel. If sleeves do not slide in easily then redrilling the hole may be necessary. 6. For the next panel, use the two closest holes of the template to mark the distance between the panels, allowing exactly three inches on center. 7.
PAGE 4
8. 9. Sometimes special width panels are required. Using standard panels follow this step by step procedure to manufacture custom length panels. (Refer to installation video for visual details) IMPORTANT: Fabric must be taut and straight in all directions. a. Determine panel length required. b. Using scissors or utility knife, cut fabric of standard panel at least 4” more than desired length. c.
PAGE 5
PROTECTAPOOL GATE INSTALLATION 1. The gate is installed between two sections of fence. 2. Gate needs to be installed along a straight run of fencing (not around a curve). 3. The gate has been notched for the hinges and can be hung from left or right side, simply by rotating the gate 180 degrees. 4. Gate should be hung so material is on outside of gate, and gate always swings out. 5. Gate posts are installed per below illustration. 6.
PAGE 6
9. Mark second hole (Point D) 5-1/2” from right gate post hole (Point C). Hole (Point D) will also contain fence pole of connecting fence section. 10. When drilling holes A and D for fence, drill plum and level with deck. 11. Drill holes for left and right gate posts (B and C) angling towards each other 4 degrees. For best results use the Cantar Protect-A-Pool Drilling Guide. 12. Continuing installing fence, attach fence to sides of gateposts with hook and eyes supplied. 13.