Manual

Page 16 of 24
Running Dante® Controller
At the time of writing this manual the Dante® Controller looks as per the screenshot
below:
The MinFernos will have been named at the factory during test to allow them to be
identified by the Dante® controller.
The format used for the factory name is:
‘MinFerno-sedrial-103-II-ob7a2c’
Where ‘MinFerno-serial-103’ refers to the Glensound product i.e. MinFerno and its
serial no (in this case 103) and ‘II-ob7a2c’ refers to the units Dante® Brooklyn II
module MAC address.
Dante® Controller TIP
If you have never run Dante® controller before then make sure that on the bottom
left of the Dante® controllers’ screen ‘P’ or ‘S’ is next to a green square as this
indicates that it is connected to a network. By clicking ‘P’ or ‘S’ a pop up box opens
to allow you to set what network interface the controller is using.