Manual

Page 15 of 24
CONNECTING THE MINFERNO TO A DANTE® NETWORK
The MinFerno is a network audio device utilizing the reliable and versatile Dante®
audio over IP protocol. Dante® is a proprietary system (although very widely used)
the originators of which are Audinate.
The information below is only meant as a very basic guide. Full details of the power
of Dante® network audio and instructions for using it can be found at
www.audinate.com
Getting Dante® Controller
If you are connecting the MinFerno to a new Dante® network the first thing you will
need to do is to get the free Dante® controller software from Audinate.
This can be downloaded by visiting Audinate’s web site at www.audinate.com
Connecting MinFernos To The Network
MinFernos can be connected to the network that you are going to use for your audio
distribution simply by plugging in either, and, or any of the network connections on
the rear. Once connected to the network it will be possible to see the MinFerno from
within the Dante® controller and route its’ audio circuits.
Audio Over IP Network
We strongly recommend that you consider your network topology carefully and
would not recommend sharing broadcast audio and general data on the same
network.
For more details of audio over IP network structure please visit www.audinate.com