Manual

Page 14 of 24
APPLE COMPUTERS
Please note that when using a browser on an Apple Mac or a Macbook, ‘.local’ must
be added to the end of the name in the browser’s bar, to access the Minferno’s web
server. For example, ‘minferno000106.local’.
IP ADDRESSES
1. General
The MinFerno uses two IP addresses on the primary Dante® network. The first is
the standard Dante® IP address, the second is the MinFerno web interface IP
address. These addresses must be different.
2. Setting a static IP address for the Dante® Interface
In Dante® Controller, use the ‘Network Config’ tab of the ‘Device View’ window to set
the required IP address.
3. Setting a static IP address for the MinFerno web Interface
On the ‘Network’ page of the MinFerno web interface, set the required IP address
and untick the DHCP tickbox.
RESETTING AN MINFERNO THAT HAS A WEBPAGE STATIC IP
1. General
It is possible to set static IP addresses on the internal web server. If this has been
set and the MinFerno moved to a different network with different subnet range then it
is not easy to find the MinFerno on the new network.
2. Reset to DHCP
To disable a preset static IP address and re-enable DHCP do the following:
A) Start with the MinFerno turned off.
B) While turning on (applying power) press and hold talkback buttons 1 and 2
C) All the front panel switch lights will flash
D) Wait until just talkback 1 & 2 lights are on and all others are off (about 20
seconds)
E) Turn the MinFerno off (remove the power source).
F) DHCP will now be enabled when you next power the unit up.