Data Sheet

Dante® Commentary
www.glensound.co.ukwww.glensound.com
MINFERNO
The MinFerno/3 has an internal web server that provides web pages for an operator to
view when pointing a web browser at the MinFerno/3 web address. The MinFerno/3
uses a very useful network protocol called DNS (Domain Name System) allowing just
‘MinFerno and the units serial number’ to be entered in a browser’s address bar to
connect. This is very useful if the IP address is not known. The webpages provide full
setup & on air controls for the MinFerno/3.
Ÿ
Web Page Remote Control
Ÿ
Mic ON/OFF, Gain & Meter
One of the web pages allows access to the gain of the
microphone meaning that the input gain can be
adjusted completely remotely. The same page also
provides the ability to turn the microphone on/off
(and of course see its current state). A level meter is
also provided on the same page so as any gain
adjustments can be accurately monitored.
Full control of how each of the 4 (3 talkback & 1 main
mic) switches operate is provided. Each switch can be
set to operate in the following modes: off, momentary
on, latching, intelligent, momentary off (cough). The
routing of the associated headphone input can also
be forced or locked and the ability to fully attenuate
the incoming source is also available.
Ÿ
Channel Operation Configuration Page
Ÿ
Channel Effect Configuration
The MinFerno/3’s channel effect page allows the interaction between the talkback &
mic switches to be set. Each channel can be set individually to either temporarily or
permanently suppress (or not) any of the other channels that are already active when
it is operated.
Web Page Remote Control