Manual

Page 9 of 24
REAR PANEL LAYOUT & FUNCTIONS
PLEASE NOTE AS THE UNIT IS CONFIGURABLE IT IS POSIBLE TO CHANGE THE OPERATION OF SOME
OF THE CONTROLS SHOWN HERE. THEREFORE THE FOLLOWING IS MEANT AS A GUIDE ONLY.
1) Mic/Line 2) PH PWR 3) Input Gain 4) Power Status
10) Identify 9) Reset 8) USB 7) EXT DC 6) SFP 5) Ethercons
1. Mic/ Line Select
Pressing the switch toggles the coarse input gain between mic and line as indicated by
the LEDs
2. Phantom Power (48V) Select
This switch turns the phantom power on/off. Phantom power cannot be turned on if
the input mode is set to ‘Line’
3. Input Gain
The up/ down push buttons increase/ decrease the units gain. Each time a button is
pressed the gain increases/ decreases by about 0.33 dB.
The ‘LINEUP’ LED indicates when the gain is in the factory pre-set lineup condition
which is:
INPUT SELECTED GAIN OF MIC AMP OUTPUT LEVEL
MIC 58dB 0dB
MIC + PH PWR 35dB 0dB
LINE 0dB 0dB
11) Input
12)
Headphones