Manual

Page 10 of 24
The ‘HIGHER’ / ‘LOWER’ LEDS indicate where the current gain setting is in relation to
line up
Holding BOTH up/ down gain controls for a few seconds returns the input gain to
factory lineup levels.
4. Power Status LEDs
For redundancy purposes the MinFerno can be powered from multiple power sources.
It can be powered from any of the following.
A. EXT DC (12V)
B. Power Over Ethernet (PoE) on the primary Ethernet network connection
C. Power Over Ethernet (PoE) on the secondary Ethernet network connection
The LEDs indicate which power sources are currently available.
5. Primary & Secondary Ethernet Network Ports
These 2 standard network ports can be connected to your IP network. By default the
MinFerno is shipped with these ports set to switch mode.
6. Primary & Secondary SFP Fibre Network Ports
Standard SFP Fibre network interface modules can be fitted in these 2 ports. SFP
modules are available in many different formats, if required Glensound can supply
suitable SFP modules, contact [e-mail] for further information.
7. 12V DC Power Inlet
This is a 2 pin barrel type DC input connector. The centre pin is 2.5mm. It is wired centre
pin + Volts. It is designed to accept a + volt DC input between 9 and 15 volts. The
connector has a barrel locking mechanism allowing specialist locking barrel connectors
to be used, a suitable mating part is manufactured by KYCON and their part number is
KLDX-PA-0202-B-LT
8. USB Socket
This is used for connecting a PC to the MinFerno for updating its firmware.
9. Reset Switch
Only use if advised to by support
10. Identify Switch
Currently used as an aid to updating software, only use if advised to by support.
11. Mic / Line Input
This standard 3 pin XLR socket is the commentators microphone input.
12. 3.5mm & 6.35mm Headphone Jack Outputs
A standard 3 pin stereo 3.5mm jack socket and 6.35mm jack socket are provided for
connecting the commentator’s headphones to.