Data Sheet
Dante® Commentary
www.glensound.com
Four off rear panel LEDs show the availability of the 3 power sources.
The SFP (Small Form-Factor Pluggable) fibre slots are standard networking ports that
accept standard SFP modules. This means that you decide what type of fibre and
connector style you want to use just by the SFP module that you insert. The primary &
secondary network circuits allow for glitch free redundancy across both the Fibre &
Copper network interfaces.
Ÿ
Primary & Secondary SFP Slots
The gain can also be altered remotely by a web browser pointing at the MinFerno/0
web page.
2) PoE on the Secondary CAT5 Network link
3) External 12V DC
Ÿ
Redundant Powering Options
One pair of push buttons selects the input type of the front panel XLR to be either
microphone, line or microphone with 48V phantom power. Three LEDs indicate
which input mode is selected.
1) PoE on the Primary CAT5 Network link
Two CAT6 connections on Neutrik Ethercons (that accept standard networking
cables) are provided to allow copper connections to local network switches to carry
the Dante®/ AES67 audio. Two connections are fitted to allow redundant circuits to
be used if required. Both these connectors can accept a PoE power source for
providing the power to the MinFerno/0.
Ÿ
Input Mode & Gain
Ÿ
Primary & Secondary Copper Network Connections with PoE
The MinFerno/0 can be powered from any of 3 different sources:
Two push buttons are used to alter the gain of the input. LEDs indicate if the gain
setting is above or below our pre-configured ‘lineup’ levels. The front panel PPM of
course provides an accurate indication of the input level.
MinFerno/0
Commentator’s Box
Rear Panel Features