Datasheet

Three commentator inputs (Two main with third position sharing)
All inputs have adjustable gain with mic, mic +12v phantom(+48v available),
and line level selection
Global LF cut on the inputs
Commentators headphones have 6(7) independent sources
Each input is switchable to left ear, right ear, or both
-70 dBu to -50 dBu
-45 dBu to -25dBu
-10 dBu to +10dBu
+12v @ 3.2Ma (48v available on request)
-30 dBu (gain@60dB)
>-60dB (gain@60dB)
<0.1% (50Hz to 20 kHz)
>-2dB (26 Hz to 16 kHz)
-3dB @ 80 Hz, -3dB @ 12 kHz
Individual outputs of the 3 inputs
Three output options per input: 1) -20dB no limiter, 2) 0dB no limiter, 3) 0dB with
compressor / limiter
Three talkback circuits as either lazy, momentary or both
Separate switches for talkback circuits for each of the main two commentators
1 mix output of the 3 inputs (at 0dB)
Local record output
Two headphone amps – one for each of the two main commentators
Each headphone amp has two Switchcraft 6.35mm jack sockets (A or B Gauge)
for connection of two pairs of headphone
Inputs on female XLR: 1-GND, 2-HOT (phase), 3-COLD (antiphase)
Outputs on male XLR: 1-GND, 2-HOT(phase), 3-COLD (antiphase)
Local record on 3.55mm stereo jack socket: TIP-signal, RING-signal,
SLEEVE-GND. Mono plugs may be used without damage.
Headphone outputs on 6.35mm stereo jack socket: TIP-L signal, RING-R
signal, SLEEVE-ground. Accepts A or B gauge jack plugs.
Channel on/off switches are user set between on/off or cough.
7 Segment LED PPM
Internal switch mode PSU (100-250v)
External 9-18v DC (power consumption less than 10w)
Power on LED
See relevant version description.
200 to 2k ohms
Max +19dBu into 600ohm - WARNING - High headphone levels can be harmful
to hearing.
Outputs
Mic Input Gain
Mic +Phtm Power Gain
Line Input
Phtm Power
Max Input Level
Noise
Distortion
Frequency Response
Filter
Headphone Impedence
Headphone Level
Inputs
General
Connections:
Power
Dimensions:
The GS-CU001 is highly customisable. If you have specific needs and you
would like a modification to one of our base units then please let us know as we
would be happy to accommodate. Here is a selection of what we can apply to
any version:
1) We can add 48v phantom power.
2) We can print any wording in any language.
3) We can add additional outputs either single source or mixed.
4) We can change the level controls for the inputs to go down to ‘off’ or ‘dim’.
5) We can put the mic gain on fixed position switches rather than a rotary
control.
6) Plus whatever else you can think of!
For version specific specifications please see version description
Glensound Electronics
Specifications
www.glensound.co.uk
Sample of options available on all versions: