Manual

Page 15 of 26
Running DANTE® Controller
At the time of writing this manual the DANTE® Controller looks as per the
screenshot below:
NOTE: The Dark8ADI only transmits into the Dante® network and therefore only
appears on the transmitters section of Dante® controller.
The DARK8ADI will have been named at the factory during test to allow them to be
identified by the DANTE® controller.
The format used for the factory name is:
‘DARK8ADI-sn-XXX
Where ‘DARK8ADI-no-XXX’ refers to the Glensound product i.e. DARK8ADI and its
serial no.
DANTE® Controller TIP
If you have never run DANTE® controller before then make sure that on the bottom
left of the DANTE® controllers’ screen ‘P’ or ‘S’ is next to a green square as this
indicates that it is connected to a network. By clicking ‘P’ or ‘S’ a pop up box opens
to allow you to set what network interface the controller is using.