Dear Customer, If you follow the recommendations contained in this Instruction Manual, our appliance will give you constant high performance and will remain efficient for many years to come.
clean air. * The minimum distance is 750mm from the range hood to a gas hob, and is 650mm to an electric hob. If the installation instructions for gas hobs specify a greater distance, this must be taken into account. NOTICE: Two or more people are required to install or move this appliance. Failure to do so can cause physical injuries. USE * The range hood has been designed only for domestic use to eliminate kitchen fumes. * Never use the hood for purposes other than what it has been designed for.
WARNING!! In certain circumstances electrical appliances may be a danger hazard. * Do not check the status of the filters while the cooker hood is operating * Do not touch the light bulbs after appliance use * Do not disconnect the appliance with wet hands. * To reduce the risk of fire or electric shock, do not use this fan with any solid-state.
* The exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. CHARACTERISTICS DIMENSIONS INSTALLATION & USE OPERATION OF CONTROLS The hood is operated using the push button on the front panel. The light switch turns the lamps on and off.
3 - HIGH SPEED Grease Filters The grease filters should be cleaned frequently. Use a warm detergent solution. Grease filters are washable. See “INSTALL FILTERS” section for removal and installation instructions. Non-Ducted Recirculation charcoal filter The non-ducted recirculation charcoal filter should be changed every 6 months. See “INSTALL FILTERS” section for removal and installation instructions.
Turn off electrical power at service entrance before wiring. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. INSTALL THE HOOD Note 1 : On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and chimney prior to final installation. Note 2: At least two people will be required to mount the hood.
7. Level the hood and secure the chimney with 2 chimney bracket screws. 8. Fix the Decorative Chimney Bottom with 3 decorative Chimney Bottom screws from inside of body. Chimney Mounting Bracket Duct Discharge Collar ST5*50 Hood Mounting Bracket Air outlet Adapter Decorative Chimney Top Decorative Chimney Bottom Hood Body INSTALL FILTERS 1. To remove the grease filter, push in on the metal latch tab. This will disengage the filter from the hood. Tilt the filter downward and remove. 2.
5.
GLEM GAS AUSTRALASIA PTY. LTD. PRODUCT WARRANTY Thank you for choosing an Emilia Glem Appliance, the purchase of this appliance is an important investment in your home and so to protect your investment we urge you to complete the registration card attached, please return it immediately. IT IS A WARRANTY REQUIREMENT THAT PROOF OF PURCHASE BE PROVIDED PRIOR TO REQUESTING A SERVICE CALL. THIS WARRANTY SHALL NOT APPLY IF THE APPLIANCE WAS NOT INSTALLED BY A LICENSED TECHNICIAN AND PROOF IS NOT SUPPLIED.
