Datasheet

9-10 Screen Copy
This command copies a single raster line of data to the graphic area.
The start point must be set using the Set Address Pointer command.
Note 1: If the attribute function is being used, this command is not available. (With Attribute data is graphic
area data.)
Note 2: With Dual-Scan, this command cannot be used (because the RA6963 cannot separate the upper
screen data and lower screen data).
Refer to the following flowchart.
Note: This command is available when hardware column number is the same. Hardware column
number is related to MD2 and MD3 setting. Software column number is related to Set Text Area and
Set Graphic Area command.