Installation

4
Installing a
Recessed & Semi-Recessed
Mirrored Cabinet
A. Determine the rough opening for the cabinet. Refer to
“R.O.” formula chart on page 3. Opening must be plumb
and level.
B. Cabinet can be hinged on left or right. Simply ip the
cabinet to change hinge location. For multiple cabinet
units determine the hinge location for each unit before
they are joined together and mark the top of each unit.
C. Insert cabinet in R.O. and center, Cabinet Flange cov-
ers any space in the R.O. around the cabinet and should
cover the nished surfaces--Sheetrock and/or tile.
Install the cabinet with four (4) #10 x 1 1/2” wood screws
(supplied). Use the pre-punched holes above and below
the hinge plates (as shown). Do not overtighten. Cover
screws with four screw caps (part #434).
For Multiple Cabinets: Two or Three unit cabinets must
be joined as shown on the facing page before installation.
Note: Three cabinet units require an additional installation
screw in the top center of the center unit. Drill an access
hole in the cabinet and install an additional #10 x 1 1/2”
wood screw. Cover the screws with four or ve screw
caps (part #434).
2x4
Framing
Shown
PLUMB
LEVEL
B
A
C
Hinge Plate shown for right hinged door.