Installation

IMPORTANT: Determine if your Tub/Shower Stall
Enclosure ledge is Level and Walls are plumb.
If they are out of Level/Plumb, by more than 3/8”,
STOP! and call Customer Service.
The Phone number is 1-888-683-1362 .
If they are Level/Plumb, or out of Plumb for less than
3/8” proceed with installation.
SPECIAL NOTE:
2 3/4” MINIMUM CURB WIDTH REQUIRED.
When ordering replacement parts,please specify the
Model Number, Item Number & Part Description.
Save these Installation Instructions For
Future Reference.
Write your Dealer information down on Notes Section.
Ask your Dealer for JOB LOG NUMBER (Lxxxxxx-xxx)
referencing to your shower enclosure.
Parts
3
Unpacking: • A box Cutter should not be use to open any box.
• Please remove all staples from the box prior to unpacking metal and glass.
• Stand Panels upright on a cushioned base, such as a piece of carpet or towel.
• Never place glass directly on hard surfaces.
• Any assembly that requires the panel to lay flat must be on a cushion surface.
IMPORTANT: Read all instructions carefully and become familiar with all parts before installation.
1
Header
Bracket
2
Header
3
Inside Door
Stop
4
Outside Door
Stop
6
Inside Door
Roller
8
Flathead Screw
9
Anchor
7
Outside Door
Roller
16
”A” Vinyl
15
Towel Bar
14
Hex Key Set
13
Center Guide
Leaf
12
Curb Dam
(From Inside)
11
Roller Adjustment
Wrench
10
Center Guide
(From Inside)
17
”H” Vinyl
(Vertical Splash Guard)
18
BOTTOM GUARD
(Horizontal Poly
Splash Guard)
5 Glass Doors
Header
(Section view)
VERY IMPORTANT -- If your installation includes a
RETURN PANEL consult the instructions and part list
for the Return Panel and follow those steps.