Installation

11
STEP 12. Measure to Position the Curb Dam
Assemble the Curb Dam (as cut to size) with the Center
Guide. Slide the Center Guide under the Inner door. (Be
sure to align the Center Guide with the mark for the
screw hole). Be sure to use the marked
position of the Curb Dam following the pencil lines at
each end on the wall and across the outside edge of the
base. Tape into temporary position. Test the Inner door
for smooth movement holding the Center Guide in
position.
STEP 13. Lift out the Center Guide and Curb Damp, tilt
the door slightly to the inside to protect the glass and
drill the hole for the Center Guide. Insert a small
amount of silicone and the Anchor. Wipe the base
clean of all debris. Clean surface with denatured alco-
hol (Do Not remove the pencil marks for the outside of
the Curb Dam.)
Centerline
Pencil line for
Curb Dam
position
Position the Curb Dam
pencil mark for outside
edge 1 15/32” from the
center line.
Detail 12C— Section View Detail 12D — Center Guide Detail
Detail 12B— Top view
Detail 12A
Mark the holes, drill and
install the anchor.
Shows the Curb
Dam within the
Center Guide with
Double Faced Tape
Guide Leaf
Optional Upgrade
Poly Splash Guard shown
installed on inside door
Inside view