Spec Sheet

ACERO Frameless Tub Shower Enclosure
AT-60T-38, AT-66T-38
Distinctive Designs for Selective Tastes
GLASSCRAFTERS, INC.
193 Veterans Blvd. Carlstadt, NJ 07072
1+ [phone] (F) 1+ [phone]
[e-mail]
Detail — Inside View, Rail with Roller
2 1/8”
1 5/8”
1 1/4”
2 13/16”
Anty-lift
Standoff
Door
Stop
Horizontal
Rail
Roller
“A” Vinyl
I
INSTALLING
THESE UNITS
REQUIRES
2 PERSONS
AT-60T-38, Polished Stainless Steel
AT-66T-38, Brushed Stainless Steel
Model Number
Width (A)
Min-Max
Overlap
Max - Min
Walk Through
Min-Max
57" to 60"
63" to 66"
4" to 1"
4" to 1"
24" to 27"
27" to 30"
FOR BEST RESULTS Glasscrafters
recommends the installation be
performed by a trained installer.
WARNING: TO INSTALL ON CAST IRON, FIBERGLASS,
ACRYLIC OR RESIN SHOWER BASE Check with the tub or
shower base manufacturer to determine the tooling required.
H
E
I
G
H
T
A A
Refer to the chart below to select the model number
that fits the Width (A) for your installation.
Tub Height is 66” — 3/8" Cleartek™ (low iron) glass
All Units are available in Polished Stainless Steel, Brushed Stainless Steel
or Iron-Black (add “PSS”, “BSS” or “IBK” to model code)
Clear
(Standard) Glass
Cleartek™
(Low-Iron) Glass
Ladder Handle
GLASS & HARDWARE
Cleartek™ (Low-iron) glass is a super clear glass with
significantly less color than standard clear glass, but is
not color free. The larger the panel, the more noticeable
the tint in the glass, especially on the edges.
Polished Stainless
Steel (PSS)
Brushed Stainless
Steel (BSS)
DECORATIVE HARDWARE FINISH OPTIONS
Iron-Black
(IBK)
Detail — Top View, Installed, Closed Position
Detail — Ladder Handle
Detail — Top View
5/8”
1 1/4”
Horizontal
Rail
Door
Stop
Panel
Glass
Vertical
Wall Jamb
Horizontal
Rail Mounting
Bracket
Detail — Top View, Closed Position
1 7/8”
10”
6”
5”
3/4”
1 1/2”
Handle
Inside
Handle
Outside
Door
Glass
Detail — Section Side View Installed
1 7/8"
Roller
Door
Glass
Horizontal
Rail
Anty-lift
Standoff
Center
Guide
Panel
Glass
Panel
Glass in
Bottom “U” Channel
Center
Guide
Door
Glass
Curb Dam
Clear “H” Vinyl
5/8”