Installation

STEP 4 -- Assemble the Horizontal Rail on the Fixed
Panel for position:
a) The Panel Screws are shipped in position on the
Horizontal Rail. Unscrew to assemble the Horizontal
Rail on inside of the fixed glass panel.
(See Details 4a & 4b).
Attach the Horizontal Rail to the Fixed Panel on the
inside face using the two Panel Screw Assembly sets
supplied pre-installed on the Horizontal Rail. ( See detail
#4) Be sure the assembly is secure and tighten the set
screw on the Panel Screws with the Allen Wrench
supplied.
Next, slide both Door Stop/Bumpers on the Horizontal
Rail, one at each end of the Horizontal Rail with the
rubber bumper facing to the middle. Temporarily
tighten to hold in place. Then slide the Horizontal Rail
Mounting Wall Brackets fully on both ends of the
Horizontal Rail and tighten into place. Test fit the
assembly next to the bottom U Channel and in the Wall
Channel. It should fit in the opening with not more than
3/16” space at either end to allow for adjustment within
the wall bracket. Move outside the unit and stand the
glass on a carpet or padding to protect the glass.
8
DETAIL #4c -- Assemble The Header for test fit
DETAIL #4d -- Test Fit the Header and Fixed panel
DETAIL #4a-- Horizontal Rail
installed on the Fixed Panel
(As viewed from the inside)
Panel Screws
Door Bumper
Door Bumper
Rail Mounting
Wall Brackets
Rail Mounting
Wall Brackets
Horizontal Rail
Detail 4b -- Test Fit of Assembled Horizontal Rail
3/16” space to allow for adjustment