Installation Guide

Disassemble the cabinet door(s)

After taking out the cabinet, disassembling the

door(s).

The door(s) can be quickly removed by pushing the

button on hinge.

Unclipping the door from the mounting plate.

IMPORTANT:

WalI Mount Installation

Installing the mounting brackets and mounting the

Cabinet Body on wall

(Please read the remarks carefully before starting)

bottom slot

Measure and mark the bottom mounting holes on the wall

corresponding to the pre-drilled hole locations in the bottom

mounting bracket (Draw horizontal line connecting the two

bottom marked locations. The line should to be level and

make sure the bracket is located in the middle of the bottom

slot.) Install the screws (C) to fix the bottom bracket

to the remarks.

Put the cabinet body on the bottom bracket and ensure the

bracket has been inserted into the slot.

Insert the top brackets into the top slot and move them to

correct locations (3”-4” from the sides of cabinet body. For

some items with 3 top brackets, locate the last one in the

middle of top slot). Mark the holes on the wall corresponding

the pre-drilled hole locations for top mounting brackets.

Install the screws (C) to fix the top brackets according to the

remarks.

Remarks for fixing brackets:

- Drywall: remove the screws from the Drywall wall plugs

(D). Using a Phillips head screwdriver in the end of the

Drywall plug, gently apply pressure and rotate clockwise.

The plug will bore its own hole into the Drywall.

Continue until the end of the plug is close to flush with

the wall. WARNING: DO NOT OVER-TIGHTEN.

- Masonry: Drill holes using a 1/4” masonry drill bit. With a

hammer, gently tap each Green anchor (E) into the holes

until flush with the wall surface.

- Timber: Drill holes using a 1/8” wood drill bit. Anchors are

not necessary.

When determining the height of product,

verify that the doors will clear all obstacles

(such as a faucet or light fixture). A minimum distance

of 3” (76mm) is required.

top slot opening

3-4”