Installation Guide
05
Set the fixed panel in place.
Place a ⁄" rubber block inside each floor clip. Rubber
blocks are not required in the wall clips.
Carefully place the fixed panel into the floor clips and
slot it into the wall clips. Partially tighten screws.
Use a level on the outer-edge to ensure the fixed panel
is level and in line.
06
Tip: Use additional rubber blocks in
either of the floor clips to raise/drop
the fixed panel if required.
Apply silicone to seal fixed panel.
Apply silicone around the wall and floor surface of the
panel. You need to silicone both the inside and outside
edges ensuring the gap between glass and tile is
completely sealed.
If you used 2 rubber blocks on your fiberglass base
instead of the boom clips, trim excess block on both
sides of glass panel before applying silicone.
Once sealed, spray the silicone with water and use a spatula
(available in our Install Kit) to remove any silicone residue.
Important: It is critical that the
silicone is given 24 hours to set and
48 hours to cure.