Installation Guide
04
Fix anchors and clips.
Using a hammer, carefully insert the green wall and
floor anchors. Trim any excess from the plug hanging
out of hole so your clips can sit flush to wall and floor.
Place clips over holes and drill in screws to secure the
clips. Make sure these are securely tightened.
03
Drill the holes for clips to fix to the wall and floor.
Using ¼" tile drill bit, drill the three marked holes on the wall
and floor. If the shower base is tiled, use the same ¼" tile drill
bit to drill the third hole on the floor. If the shower base is
fiberglass, use ⅛" drill bit for the floor hole. You will not use
the green anchor but rather screw the floor clip directly
into base. If you do not want to drill into the fiberglass base,
place ⁄" rubber blocks on threshold 3" in from both sides
of glass panel and do not use the boom floor clip. (See
Step 05 showing placement of rubber block. The second
block would be placed where the clip is shown.)
Important: There is stamp on the corner of all Glass Warehouse glass panels to certify it is tempered
safety glass. We recommend panels are installed with the stamp at the boom corner closest to the
wall where it is less noticeable. On Door Panels, the stamp must be at the boom for your enclosure
to align properly. Note: the stamp is baked on during the tempering process and cannot be removed.