GW-FSS- 34"- 40" Shower Enclosure Installation Guide Esprit French Silk Screen Single Fixed Shower Panel
A B x4 x4 C Included in your purchase: A Fixed panel B Clips, screws and anchors C Rubber block set (various sizes)
Thank you for your purchase. If for any reason you are having trouble with installation, or if the size of the product does not fit your designated space, please contact Glass Warehouse directly and do not return this product to place of purchase. We will be able to exchange the panels or parts to suit your opening. Glass Warehouse takes pride in providing quality products and customer service. We want to ensure your happiness with your purchase for years to come.
Installation Guide 1⁄8" A B C D E ¼" F G H I J Tools required for install A B C D E Silicone and caulking gun Power drill Phillips head screwdriver Pencil ⅛" tile drill bit F G H I J ¼" tile drill bit Utility knife Level Hammer Tape measure Note: Silicone is not provided and will need to be purchased separately. We recommend using a clear, mold resistant silicone which can be purchased at your local hardware store.
70 " 8" 3 ½" from wall W– 3 ½" from outer edge of glass width 01 02 Measure and mark the fixed panel location. Mark the four clip locations. Use a level and mark a line up the wall and along the floor. This is your center line for the clips. A 70" from the floor, up the vertical line. B 8" from the floor, up the vertical line. C 3 ½" out from the wall on the floor. Important: This panel is fully reversible and can be installed on right or left hand wall as needed.
03 04 Drill the holes for clips to fix to the wall and floor. Fix anchors and clips. Using ¼" tile drill bit, drill the three marked holes on the wall and floor. If the shower base is tiled, use the same ¼" tile drill bit to drill the third hole on the floor. If the shower base is fiberglass, use ⅛" drill bit for the floor hole. You will not use the green anchor but rather screw the floor clip directly into base.
05 06 Set the fixed panel in place. Apply silicone to seal fixed panel. Place a 1⁄16" rubber block inside each floor clip. Rubber blocks are not required in the wall clips. Apply silicone around the wall and floor surface of the panel. You need to silicone both the inside and outside edges ensuring the gap between glass and tile is completely sealed. Carefully place the fixed panel into the floor clips and slot it into the wall clips. Partially tighten screws.
07 Once silicone has cured, you're done. Please register your warranty using the instructions on the back cover of this document.
Care & Maintenance EnduroShield makes cleaning easier and less frequent; however it is recommended that you continue to clean the surfaces regularly. Maintaining the Treated Surface Approved Cleaning Products For best results simply drying the glass with a squeegee or towel after each use will help keep the glass clean and reduce mineral spots forming.
Exclusive Limited Warranty Terms & Conditions. This warranty is effective as of JANUARY 1, 2019 on all Glass Warehouse product purchases PLEASE READ GLASS WAREHOUSE WARRANTY TERMS AND CONDITIONS BEFORE INSTALLING YOUR GLASS WAREHOUSE PRODUCT. BY USING THE PRODUCT, YOU ARE CONSENTING TO BE BOUND BY THE FOLLOWING WARRANTY TERMS AND CONDITIONS Glass Warehouse offers the following warranty for its products and components thereof.
obligation shall be discharged upon tender of parts, replacement or repair of the product. Purchaser’s refusal to accept the tender terminates all warranty obligations and VOIDS THE WARRANTY. Cost of freight for returning products to Glass Warehouse for repairs or replacement under this limited warranty are the responsibility of the customer. Cost of freight associated with shipping of replacement product(s) or parts covered by this warranty is the responsibility of the original user.
Register Your Warranty Today! To activate your limited lifetime warranty, please visit: http://www.glasswarehouse.us/contact/ We will require this information within 30 days of purchase to complete the activation of your warranty.
