90-WH Shower Enclosure Installation Guide Illume 90º Wall Hinge
INSTALLATION VIDEO VIMEO LINK https://vimeo.com/378378532 Follow the link above to view installation animation video to assist in installing your brand new Glass Warehouse 90° Wall Hinge Shower Enclosure For further assistance, contact GW at: inquiries@glasswarehouse.
BEFORE YOU START The most fragile parts of tempered glass panels are the corners. Therefore, it is critical you have the rubber blocks in place so the glass never touches the tile surface you are installing onto. Please make sure the glass is always on blocks while out of the packaging prior/during install. Rubber block is provided in your hardware pack however you can use wood, cardboard or other rubber products to protect against breakage. Silicon is not provided this will need to be purchased separately.
PART THREE – Install Door Panel (front) 1. 2. 3. 4. 5. 6. 7. Attach the hinges to the door panel. a. Ensure you have the hinges placed in the correct direction, screws to mount to wall are on inside of shower enclosure. b. Lightly tighten each screw with the allen keys provided so the hinges are lightly secure only. They are going to be removed again. i. TIP: Center each hinge to the cutout allowing some space to adjust the height of the door panel once installed.
Care & Maintenance EnduroShield makes your cleaning easier and less frequent; however it is recommended that you continue to clean the surfaces regularly. Maintaining the Treated Surface For best results simply drying the glass with a squeegee or towel after each use will help keep the glass clean and reduce mineral spots forming. The glass needs to be cleaned every few weeks using a damp microfiber cloth and a mild detergent to break down soaps, oils, and conditioners on the glass.
• • • • •
Register Your Warranty Today! To activate your limited lifetime warranty, please visit: http://www.glasswarehouse.us/contact/ We will require this information within 30 days of purchase to complete the activation of your warranty.
