Installation Guide

PART ONE: Install Fixed Return Panel
IMPORTANT: The most fragile parts of the glass panels are the corners.
Therefore, it is critical you have the rubber blocks in place so the
glass never touches the tile surface you are installing onto.
1. On the wall where the xed return panel is to be placed, mark a vertical
line up the wall using a level.
a. This line is where you will be attaching the 2 clips to the wall.
TIP: We recommend using a pencil so this can be easily removed.
i. To establish the center line of the xed return panel measure out from
the hinge panel wall 58 7/8″. This measurement takes you to the center
line of the return panel glass. Use a level & mark the vertical line up the
wall. This is your center line for the clips (Refer to Step 1 on illustration).
2. Mark the location of your clips on the return panel wall.
a. Top clip: measure 70 1/4″ from the oor up the vertical line and mark
this point on your line.
b. Bottom clip: measure 7 3/4″ from the oor up the vertical line and mark
this point on your line.
c. The third clip for the oor should be placed 29″ from return panel wall.
Measure 58 7/8″ from hinge panel wall to get center line for this clip on
the oor.
3. Drill the holes for clips to x to the wall and oor.
a. Using a 1/4″ drill bit drill the 3 marked holes (2 on wall and 1 on the oor).
NOTE: If you are xing oor clamp to a berglass shower base use a
1/8″ drill bit to pre-drill the hole rather than 1/4″ tile drill bit. You will not use
the green wall anchor but rather screw the clip directly to berglass base.
b. Insert the provided wall/oor anchors, you will need to use a hammer to
put these in. Be careful to not break tiles. Cut any excess from the plug
hanging out of hole so your clip can nish ush to wall/oor.
c. Place clips over holes and drill in screws to secure the clips.
Make sure these are securely tightened.
4. Set the xed panel in place.
a. Place the 1/8″ rubber block provided on the ground 3″ from the edge
of the panel closest to wall and place the 1/16″ rubber block inside the
clip on the oor to prevent the glass touching the tile or clip on the oor
where all the glass weight will be. Rubber blocks are not required in the
wall clips.
b. Carefully place the xed panel on the rubber blocks and slot the glass
into the wall clips.
5. Ensure the xed panel is level. On the edge that will meet the door panel,
use a level to make sure the xed panel is level and in line.
TIP: Use additional rubber blocks on either end of bottom of glass panel
to raise/drop the xed panel if required to make glass level.