Installation Guide
BEFORE YOU START
The most fragile parts of tempered glass panels are the corners.
Therefore, it is critical you have the rubber blocks in place so
the glass never touches the tile surface you are installing onto.
Please make sure the glass is always on cardboard packaging
or rubber blocks while out of the packaging prior/during install.
Rubber block is provided in your hardware pack however you
can use wood, cardboard or other rubber products to protect
against breakage.
Silicone is not provided and this will need to be purchased
separately. We recommend using clear, mold resistant
silicone which be purchased at your local hardware store.
ATTENTION INSTALLER:
A light haze or smudging may be present on the coated glass
on delivery. This is easily removed by washing with denatured or
isopropyl alcohol and a good quality microber cloth, followed
by a rinse of water. This can be done before or after installation.
The items included for this shower enclosure are listed
below. This will have been shipped in 5 packages:
1. Door panel
2. Hinge panel
3. Fixed panel
4. GH Sweep set – (1 full length sweep, 1 bottom sweep)
5. Hardware Pack – (2 hinges, 6 mounting clips,
1 door handle, 2x 45° shower rod)
Tools needed for install: