Installation Guide

Drill holes, fix anchors and clips, then set hinge panel.
Repeating steps 03, 04 and 05:
Drill holes in new locations. Carefully use a hammer to
insert anchors, then screw clips in place.
Place the ⅛" rubber block on the floor 3" from the wall.
Place the ⁄" rubber block inside the floor clip. Carefully
place the hinge panel on the rubber blocks and slot it
into the wall clips. Partially tighten screws.
Use a level on the outer-edge to ensure the hinge panel
is level and in line.
0807
Mark the three clip locations.
A 70 ¼" from the floor, up the vertical line.
B 7 ¾" from the floor, up the vertical line.
C Measure the width of the hinge panel and subtract
3 ½". Use this measurement to calculate the floor
clip's distance from the hinge panel wall, along the
floor line.
7 ¾"
W–3 ½"
70 ¼"