Installation Guide

04
Fix anchors and clips.
Using a hammer, carefully insert the green wall and
floor anchors. Trim any excess from the plug hanging
out of hole so your clips can sit flush to wall and floor.
Place clips over holes and drill in screws to secure the
clips. Make sure these are securely tightened.
03
Drill the holes for clips to fix to the wall and floor.
Using a ¼" tile drill bit, drill the two marked holes on the
fixed return wall.
If the shower base is tiled, use the same ¼" tile drill bit to
drill the third hole on the shower floor.
If the shower base is fiberglass, use a ⅛" drill bit for the
floor hole. You will not use the green wall anchor but
rather screw the floor clip directly to fiberglass base.