Installation Guide
14 15
Tighten hinge screws and you're done.
Put the backing plates on hinges and tighten all four
screws on both hinges.
Ensure the screws are very tight and supporting the
door's weight. Then carefully remove the rubber blocks
and open the door to ensure it's not binding anywhere.
Aached the door sweep to the base of the door to
prevent water leakage from the shower.
Set the door panel in place.
Place two of the ⅜" rubber blocks on the floor between
the hinge and fixed panels — 2" from each panel.
Standing inside the shower, carefully place the door
panel on the blocks and line up the cutouts with the
back of the hinges. Check that the top of all three panels
are level. Next, check that vertical gap on either side of
the door is even.
Note: The door panel is ¼" shorter than the hinge panel
to allow for swing and door seal.