Installation Guide
12
Aach the hinges to the hinge panel.
Slide the solid plate side of the hinge in to the hinge
panel cutout, ensuring the screws face into the shower.
Lightly tighten screws.
Remove the backing plates from the hinges where the
door will aach.
Tip: Center each hinge within the cutout
will give you space to adjust the door
height once installed.
Apply silicone to seal both panels.
Trim the rubber blocks with a utility knife so that they
are flush with the glass panels resting on top of them.
Apply silicone around the wall and floor surface of
both panels. You need to silicone both the inside and
outside edges ensuring the gap between glass and tile
is completely sealed.
Once sealed, spray the silicone with water and use
a spatula (available in our Install Kit) to remove any
silicone residue.
11
Important: It is critical that the
silicone is le to cure for 36-48 hours.
Do not continue until silicone has set.