Installation Guide

Ensure both panels are level and correctly spaced.
Using a level, check the top of both panels are level and
equal height from the floor. If a panel(s) isn't level, use
additional rubber blocks to correct it.
Measure the opening between the two panels. This
should be ¼" wider than the door panel.
Once level and correctly spaced, tighten the clip screws
very tight.
09
D+¼"
Install the 45° rod. Optional for additional support.
Loosen the allen bolt inside the clip and place on top of
the hinge panel. Position the 45º rod so the other end is
flush with the wall. Mark position of screws on the wall
before removing the rod.
Using a ¼" tile drill bit, drill the two marked holes on the
wall. Then use a hammer to insert wall plugs.
Place the 45º rod back in position and drill wall screws
in to secure. Lastly, tighten the allen bolt inside the clip.
Repeat for the other panel.
10
Note: If your hinge panel is 12" or less, you'll
need to shorten the rod. Remove the end cap,
cut to the required length. Then replace the
end cap and tighten the bolt.