Installation Guide

18 2017 19

Hang Interior Door Panel

Li the Interior Door Panel and slowly lower the rollers

onto the Shower Rod. When lowering the Door Panel,

be sure the boom of Door Panel slides into the Boom

Bracket and the Sweep faces the interior of the shower.

Gently slide Door Panel from side to side making sure it

is not binding anywhere along the boom.

Check the Interior Door Panel is level and lines up

evenly with the wall. If Door Panel does not line up with

the wall, use the Open Wrench to adjust top rollers and

align Door Panel vertically with wall.

Install Boom Rollers on Interior Panel

Prepare 2 Boom Rollers by removing Interior Plate.

Begin with roller aligned with ﬂat area parallel to top

of Door Panel. Insert Roller into boom holes in Interior

Panel and reaach Interior Plate.

If you need to lower the Door Panel to access the holes

to install the boom rollers, use the Spanner Wrench to

loosen the top rollers and the Open Wrench to adjust

and lower the Door Panel for beer access.

Adjust Wheel Positions snug to Shower Rod

Using Spanner Wrench and Open Ended Wrench, adjust

wheel position to make Boom Roller snug to Shower

Rod. Reinstall Exterior Cover Plates to all 4 Rollers.

Hang Exterior Door Panel

Li the Exterior Door Panel and slowly lower the rollers