Installation Guide

13 14
Install Shower Rod Bracket Top Covers
Once Shower Rod is perfectly level, insert Top Covers
back into the Shower Rod Brackets and use the set
screws to tighten them completely. Once Top Covers
are installed, use level to confirm that Shower Rod is
completely level before installing glass.
4
x
Interior plate
Exterior
cover plate
Spanner
Wrench
Open End
Wrench
Use pliers
to adjust
Spanner
Wrench
Unpack and disassemble 4 sets of Rollers
The Rollers are shipped assembled and will need to be
taken apart for installation into the glass panels. First,
unscrew the exterior cover plate to access the interior
plate. Next, unscrew the interior plate by hand. If needed,
use open wrench and spanner wrench to loosen.
Important: Use a pair of pliers to adjust
Spanner Wrench to fit inserts on interior
cover plate.
16
Install with flat
area parallel to top
of door panel
Attach sweeps with
lips facing towards
shower interior
15
Install Top Rollers on both sliding doors
Install top 2 Rollers with flat area on wheel parallel to
top of Door Panel. (Lower Rollers are installed aer
Door Panel is hung.) Repeat this process on the other
Door Panel.
Install Boom Sweeps on both sliding doors
Measure and cut Boom Sweeps with hacksaw to fit
exactly across the boom of the Door Panel. Position
Sweeps so that the lip faces the interior of the Shower
when both Door Panels are installed.