Installation Guide

Install Shower Rod into Shower Rod Brackets
Remove Shower Rod Bracket Top Covers prior to
installing Shower Rod. Install Shower Rod into the
Shower Rod Brackets with Stoppers in correct position
for final glass panel positioning.
Check Shower Rod with level. If Shower Rod is not level,
use set screws in boom of Shower Rod Brackets to
level Shower Rod completely.
10 1209
Measure Shower Rod for cuing
Measure your opening wall to wall at 73 ⁄" up from the
threshold. Subtract ⁄" from this measurement. This is
your Final Shower Rod Length.
Subtract your Final Shower Rod Length from 73"
(73" is the initial length of the uncut Rod.) Divide this
number by two to get your final measurement.
Example: Your opening measures 58".
Final Shower Rod Length = 57⁄".
73 minus 57⁄" = 15⁄"
15⁄" divided by 2 = 7⁄"
You will remove 7⁄" from each end of the Shower Rod.
Cut Shower Rod at both ends
Important: It is necessary to cut the
Shower Rod at both ends because you
will need 2⁄" clearance between
the end of the Rod and the weld (on the
inside) once the Rod has been cut.
For this reason, you will need to cut both ends.
Wear safety goggles when using a grinder
or hacksaw as a precautionary measure.
Using your measurement from Step 09, use a hacksaw
or a special saw/grinder and remove the correct amount
from each end of the Shower Rod. The Shower Rod is
now ready for installation.
73 1⁄8"
73 1⁄8"
11
551⁄2˝
591 ⁄2˝
551⁄2˝
591 ⁄2˝
Shower Rod
Max Width: 59 1⁄2˝
Min Width: 55 1 ⁄2˝
Install Sliding Panel Stoppers
Prior to Shower Rod installation, position Sliding Panel
Stoppers on each end of Shower Rod with rubber
bumpers facing back edge of sliding glass door panels
in open position. Secure in place aer Shower Rod
is installed.