Installation Guide

Important: If installing an enclosure
with fiberglass walls, a stud must be
directly behind where the Shower Rod
Brackets will be installed.
01 02
Minimum
1 ⁄˝ (38 mm)
from edge
73 1⁄8"
73 1⁄8"
0403
Middle of
Shower
opening
Tip: We recommend using a pencil
so this can be easily removed.
Mark threshold and walls for Shower Rod position
Measure the width of threshold tile where shower door
is to be installed, this needs to be a minimum of 3" to
install this model shower enclosure. Measure to center
of threshold and mark a line down the center. Check that
line is at least 1 ⁄" from the front and back of threshold.
Using a level, draw a line up both walls from this point.
Mark location of Shower Rod Brackets
Along the drawn level lines on each wall, measure
73 ⁄" from floor. Mark this point and draw a perfectly
level horizontal line. This is where the boom of the
Shower Rod Bracket will sit.
Mark drill holes for Shower Rod Brackets
Center the Shower Rod Bracket along the vertical
line with the boom of the Bracket lined up with your
horizontal line at 73⁄". Use a pencil and mark the wall
through both holes in Shower Rod Bracket. Repeat this
process on the opposite wall.
Mark drill holes for Boom Bracket
Measure to the middle of your shower opening and
mark the exact middle point on the threshold for where
to position the Boom Bracket.
Example: If your opening is 58", you would mark a
line at 29". This will be the exact middle of your Boom
Bracket for installation.
Using this line, center the Boom Bracket on the
threshold and use a pencil to mark the drill holes.
Remove the plastic gaskets from the Boom Bracket
to mark the holes.
Important: Check the threshold with a level
before measuring for the Shower Rod Brackets.
If the threshold is more than ⁄" out of level,
measure and mark from the side of the
threshold that is higher. For the lower
side, measure and add the out of level
dierence and mark so that your
Shower Rod Brackets are installed level.