Installation Guide

731⁄8"
39"
Threshold
3" Wide
731⁄8"
39"
Interior
Panel on
right side
Interior
Panel stopper
on left side
Interior
Panel on
left side
Interior
Panel stopper
on right side
Installation Guide
Tools required for install.
A B C D
1⁄8"
E
¼"
F H I J KG
A Silicone and caulking gun
B Power drill
C Phillips head screwdriver
D Pencil
E ⅛" tile drill bit
F ¼" tile drill bit
G Hacksaw
H Utility knife
I Level
J Hammer
K Tape measure
Note: Silicone is not provided and will need to be
purchased separately. We recommend using a clear,
mold resistant silicone which can be purchased at
your local hardware store.
If your shower head is on the
right, the Inside Panel should be
installed on the right side and
the Stopper will go on the le
side (and on the inside track) of
the Shower Rod.
If your shower head is on the
le, the Inside Panel should be
installed on the le side and the
Stopper will go on the right side
(and on the inside track) of the
Shower Rod.
Before You Start
Confirm you have the correct model size
for your opening.
Model number and corresponding
size range:
2DSL-60 = 56"- 60"
• Measure if your walls are out of plumb.
It is essential your shower enclosure
is tiled before measuring as your
measurements WILL change once
tiling and grout are in place.
Take 3 Tile to Tile Measurements:
1. TOP of rod height (73⁄")
2. MIDDLE from threshold (39")
3. BOTTOM at threshold
If your walls are ⁄" or more out of plumb,
please contact Glass Warehouse
before installing.
• Measure threshold to ensure that this
model will fit. Threshold must be a
minimum of 3" wide to install this model.
• Choose which side of your shower should
have the Inside Panel (while both doors
are closed). Glass Warehouse highly
recommends installing the Interior Panel
on the same side as your shower head.
This will help to prevent water leaking
from the gap between the two
glass panels.
• If installing an enclosure with fiberglass
walls, a stud must be directly behind
where the Rod Holders and Shower Rod
will be installed.