Instructions

8035 Series User Manual
Step 3: Decide on power access
The RS-232 connection requires power +12V DC. This may be provided through an
internal connection in your computer or through an external connection to a 110/220V
adapter. The components for an internal connection are provided.
Step 4: Using internal power source
Refer to the installation diagram as below. Remove the access cover to your computer.
Mount the +12V DC power plate on an available expansion slot in the back of your
computer. Attach the 4-pin male connector to the open female connector of the same
type in your computer.Alternatively, an internal power source may be available already
if the com port on your computer or terminal matches the 8035 pin assignment.
.
Step 5: Connect to your computer
Connect the RS-232 connector to the male equivalent com port on your computer
or terminal. Provide power to the DC jack on the DB9F connector using
either a cable connection to the +12V DC power plate or an external adapter.
Step 6: Turn on your computer
Turn on your computer. It should boot up normally.
The pole display will show a self-diagnostic status and then the display will be
blank.
Step 7: Turn to Chapter 5
You are now ready for operation; please refer to Chapter 5 for programming to
meet the specific requirement of your application environment.
7