Instructions

8035 Series User Manual

Programming Commands

There is a programming mode available for model 8035 with ESC/POS mode. In this Chapter,

we will use ESC/POS mode for multi-languages, Please refer to Appendix for details.

The basic function

of the 8035 display is comparable to the display programming by

your software should be as easy. You only need open the COM-port on which the

display has been connected from you. Then, you just needs send the character what you

want to display on 8035 directly via the COM port. Please following the USB/RS232

parameters to use as below:

9600 Baud, No Parity, 8 Data Bits, 1 Stop bit

In Basic, you would initialize the interface as follows:

OPEN “COMx: 9600, N, 8, DS0” FOR OUTPUT AS #1

(x=number of the COM port you are using for the display)

And you would print something to the display using the PRINT command:

PRINT#1, “Hello World!”

In the end, you can close the interface:

CLOSE #1

In other programming languages, the commands for serial output shall be

different, but they will work in a similar way. For some compilers, you will need

an extra toolbox, that offers you usb routines. Please refer to your

compiliers/interpreters manual for more details.

Example:

OPEN “COMx: 9600, N, 8, 1, DS0” FOR OUTPUT AS #1

PRINT #1, “Hello World!”

CLOSE #1

Chapter 5