Installation & Assembly

Shelving Use Requirements

■ Maximum weight limit is 400 lbs (181 kg) for each shelf, not to

exceed 1,600 lbs (726 kg) for the entire shelving unit.

WARNING

Excessive Weight Hazard

Use two or more people to move shelving.

Failure to do so can result in back or other injury.

Unpack

NOTE: Use one person to assemble shelving and two people to

move it.

1. Remove and verify the contents. See the “Parts” section

so you can sort out all of the parts.

2. Dispose of/recycle all packaging materials.

Assemble & Complete

■ No tools or hardware required.

■ Can be assembled by one person.

IMPORTANT:

■ Determine shelf spacing before assembly.

NOTE: It is recommended to equally space the shelves from

top to bottom of the shelving unit and build it from the bottom

up. See the “End Frames/Support Beams” illustration.

■ Prior to assembly, refer to the sticker located on the inside

of one of the P4 side support beams and record model and

serial numbers on the included warranty page. There are many

benets for registering the product. Find out more and register

the product online at www.gladiatorgarageworks.com.

ASSEMBLY INSTRUCTIONS

Support Beam Orientation

NOTES:

■ It is recommended to put beams at notch 1, 9, 16, and

23 (counting from the bottom up) to keep shelving rack

balanced. Keep two of the shelves on the bottom half of

the shelving rack.

■ All support beams need to be at the same height or the

shelves will not assemble correctly.

■ During assembly press rmly on all side and horizontal

support beams (P3 and P4) to ensure they are properly

installed into the slots on top and bottom posts.

End Frames/Support Beams