Installation & Assembly

Use the bottom post (P1) and attach a horizontal support

beam (P3) across front, and attach a side support beam (P4)

to the other side. Insert horizontal and side beams starting at

the top of the slots on the upright posts and pushing down

after engagement. This will give you support while building

your shelves up. You have now assembled one corner.

1. Attach support beams to bottom

post

Repeat step 1 to assemble the other three corners,

completing the bottom shelf. Make sure to press rmly on all

side and horizontal support beams (P3 and P4) to ensure they

are properly installed in the top and bottom posts.

2. Assemble bottom

Add tie channel support (P5) to the bottom of the frame.

Rotate into place BEFORE dropping tabs in slot.

3. Add tie channel support

Repeat steps 1 and 2. We recommend adding a section at

notch 8 from the bottom of the post. Add the horizontal and

side support beams. Add tie channel support and shelf.

5. Assemble 2nd shelf

Repeat steps 1 and 2. We recommend adding a section at

notch 14 from the bottom of the post. Add the horizontal

and side support beams. Add tie channel support and shelf.

NOTE: We recommend adding 3 shelves to the bottom half

of the shelving rack for better support. Make sure to install

shelves before beginning next step.

6. Assemble 3rd shelf

Add laminate shelf to the bottom of the frame. Gently place

laminate shelf on beams and tie channel support.

4. Add 1st shelf