Installation Instructions

Position the two welded-end frames (P4) vertical with the

foot end of each frame at ground level and proﬁle slots facing

forward.

1. Assemble end frame

At the desired shelf location, align both of the support beam

(P2) end tabs with the inside triangular frame slots on the

welded frame (P4).

2. Align support beams

Rotate the tie channel support (P3) into the front and back

support beam (P2), aligning the tie channel rivet heads with

the matching large diameter hole of the support beam keyhole.

This shelving unit is equipped with one, two, or three tie

channel supports (P3) for each shelf, depending on the size

of the shelf unit.

NOTE: The tie channel supports (P3) provide load support

and structural integrity. All tie channel supports (P3) must

be assembled as shown.

3. Assemble tie channel supports

To insert the rivet head on the other side of the tie channel

support (P3), apply pressure to both sides of the tie channel

support (P3), squeezing the sides toward each other. Insert

the rivet head into the matching larger hole of the support

beam keyhole on the front and back support beam (P2).

Release pressure.

4. Rivet inserted into keyhole