Instructions / Assembly

5. Using Phillips-head screws (F3c), fasten the upper back panel

(P4) to the lower back panel (P5) and the lower back panel to the

cabinet bottom (P3).

6. Tighten all back panel screws completely.

7. Starting with the front of the cabinet, and using the Allen wrench

(provided), tighten all of the bolts completely.

Install Shelves

Plan your shelf heights and install the 2 shelves (P6 and P6m) starting

from the bottom. The shelves are supported by the metal loops on

the side walls of the cabinet.

1. Determine the placement of the 2 shelves (P6—1 shelf without

magnets, P6m—1 shelf with magnets).

2. Place the shelf in the cabinet so that the long edge with the holes

(P6) or the long edge with the magnets (P6m) is toward the front

of the cabinet.

3. Tilt the shelf so that one end is higher than the other as shown.

NOTE: The higher end of the shelf should be directly above the

cabinet loop at the desired height.

4. Push the shelf edge down so that the shelf tabs go into the

cabinet loops.

5. Lift up on the lower end of the shelf so that it is above the desired

cabinet loop and push the shelf down into place.

NOTE: Check that the shelf tabs are in place behind all the

cabinet loops, as shown.

6. Repeat steps 2 through 5 to install the other shelf.

A. Push down

B. Lift up

A. Cabinet loop

B. Shelf tab

P6m