Owner's Manual

ManualsBrandsGladiator ManualsCabinet HardwareReady to Assemble Extra Large Gearbox

ASSEMBLY INSTRUCTIONS

Tools and Parts

Gather the required tools and parts before starting installation.

Tools Needed:

■ 1/2" Wrench ■ Phillips screwdriver

■ 3/8" Wrench ■ Level

Tools Supplied:

■ Hex key

■ Key

Cabinet Use Requirements

■ Intended for use in a garage.

■ Maximum weight limit is 50 lbs (22.7 kg) for each shelf.

■ Maximum weight limit is 250 lbs (113.6 kg) for the cabinet.

Unpack the Cabinet

1. Remove and verify the contents. Contents include a hex key, a

key, and the parts and fasteners shown in “Parts.”

2. Dispose of/recycle all packaging materials.

Assemble Cabinet

IMPORTANT: Two people may be required to complete the

assembly. As you assemble the cabinet, make sure the edges

with the holes are facing up. If you are assembling the cabinet on

the oor, fasten the eight front corner bolts, two at each corner,

after you stand the cabinet upright.

WARNING

Excessive Weight Hazard

Use two or more people to move, assemble or install

cabinet.

Failure to do so can result in back or other injury.

Place side panel (P1) on a at, rm surface so that the edge

with the holes is facing up as shown. Insert the cabinet top (P2)

between the edges of side panel (P1).

NOTE: Make sure the edges with the holes are facing up.

Align the holes and attach the top (P2) to side panel (P1) using six

Hex-head bolts (F1) and two 5/16" ange nuts (F2) as shown.

Do not tighten completely. Position the other side panel (P1) so

that the top (P2) is between the edges of side panel (P1). Align the

holes and attach the top (P2) to the side (P1) using six Hex-head

bolts (F1) and two 5/16" ange nuts (F2) as shown. Do not tighten

completely. Insert the cabinet bottom (P3) between the edges of

the side panels (P1).

NOTE: Make sure the edges with the holes are facing up.

Align the holes and attach the bottom (P3) to the sides (P1) using

six Hex-head bolts (F1) and two 5/16" ange nuts (F2) for each

side as shown. Do not tighten completely.

1. Assemble Cabinet

F1 F2

F1 5/16"

hex-head bolt (24)

F2 5/16" ange nut (8)