Owner's Manual

IMPORTANT: Gladiator brand Premier Jumbo cabinet is designed

to be installed on Gladiator

GearWall

panels or GearTrack

channels. If GearTrack

channels will be used to support the

Gladiator

Premier Jumbo GearBox cabinet, you must use three

channels installed 18" (45.72 cm) apart. Be sure the GearWall

panels or GearTrack

channels are installed with mounting screws

in every slot and at every stud location with a maximum of

24" (60.96 cm) horizontally between screws.

IMPORTANT: There are slots in back panels (AAA, CCC, and

DDD) to attach the mounting brackets (P8).

With the mounting bracket rim pointing down, align the three

bracket holes with the slots in back panel (AAA), as shown.

Working from the back, insert carriage bolts (F7) through the

bracket and into top back panel (AAA). Working from the cabinet

interior, fasten each bolt with a washer (F8) and a ange nut (F2).

Fully tighten the bolts.

INSTALLATION INSTRUCTIONS

WARNING

Excessive Weight Hazard

Use two or more people to move, assemble or install

cabinet.

Failure to do so can result in back or other injury.

1. Install GearWall

panels or

GearTrack

channels

18" (46 cm)

2a. Attach Mounting Brackets

A. Bracket rims pointing down

F8F7 F2

F7 Carriage-head bolt (9)

F8 Washer (9)

F2 5/16" ange nut (9)

AAA

BBB

AAA