Owner's Manual

2. Attach Back Panels

IMPORTANT: Attach the back panels starting at the top of the

cabinet with back panel (AAA) and working down to the cabinet

bottom. Each back panel will overlap the panel below. Do not

completely tighten the screws until all back panels are in place.

Align back panel (AAA) with the holes in the cabinet top. Using

Phillips-head screws (F3c), attach back panel (AAA) to the cabinet

top and sides. Slide the top of back panel (BBB) under the bottom

of back panel (AAA). Using Phillips-head screws, fasten back

panel (BBB) to the cabinet sides. Repeat Step 2 for the remaining

back panels ending with back panel (EEE). Using Phillips-head

screws, attach each back panel to the panel below.

NOTE: Using Phillips-head screws, attach panel (EEE) to the

cabinet bottom (P3).

Completely tighten all back panel screws starting with the sides

and continuing with the top, middle and bottom. Using the hex

key (provided), completely tighten all cabinet bolts and nuts.

F3c

F3c Phillips-head screw (34)

AAA

BBB

CCC

DDD

EEE

3. Install Leveling Legs (optional)

IMPORTANT: If you are going to install the cabinet on Gladiator

GearWall

panels or GearTrack

channels, you do not need to

install leveling legs.

Place the cabinet on its side. Screw a leveling leg (P4) into each

of the four rivet nuts located at the corners of the cabinet, as

shown. Stand the cabinet upright. If you have not already done

so, fasten the two bolts at each front corner of the cabinet frame.

Completely tighten all of the cabinet bolts and nuts.

A. Leveling legs

EEE

Leveling feet (4)