Use and Care Manual

INSTALL MAX GEARLOFT™ SHELF TO THE GLADIATOR

WALL SYSTEM

1. Installing the GearTrack

channel

6" (15.24 cm)

Be sure the Gladiator

GearWall

panels or GearTrack

channels

are installed with mounting screws in every slot and at every stud

location with a maximum of 24" (60.96 cm) horizontally between

screws.

If installing the shelf on GearTrack

channel, you must use two

channels installed 6" (15.24 cm) apart.

2. Sliding the brackets into the

GearTrack

channel

43" (109.22 cm)

Determine the shelf mounting location on Gladiator

GearWall

panels or GearTrack

channel.

Insert the brackets into the GearTrack

channel so that bracket

rim extension ts behind the upper channel groove.

Slide the brackets in the GearTrack

channel so that they are

spaced 43" (109.22 cm) apart as shown in above gure.

NOTE: Install bracket into the upper channel for installations

with the braces above the shelf, or into the lower channel for

installations with the braces below the shelf.

3. Installing Max GearLoft™ Shelf

Engage the bracket that is welded to the back of the shelf into the

wall slot by lifting up, pushing toward the wall and lowering the

bracket rim into the slot as shown.

Make sure that the screws on the brackets go through the holes

in the braces. Fasten the braces to the brackets using the wing

nuts (F3).

NOTE: You may need to adjust the brackets to the right or left if

the screws do not align with the holes.

Inspect the shelf from the side to ensure the bracket rims are fully

engaged in the slots as shown.

Fully tighten the wing nuts (F3).

A. Brace attached to the Shelf

B. Shelf attached to GearTrack