Use and Care Manual

4
INSTALLATION INSTRUCTIONS
Max GearLoft™ Shelf Use
Requirements
■ Intended to be installed on Gladiator
®
GearWall
®
panels or
GearTrack
®
channels.
■ Maximum weight limit is 200 lbs (91 kg).
Unpack the Max GearLoft™ Shelf
Parts
1. Remove and verify the contents. Contents include a hex key,
and the parts and fasteners shown in “Parts.”
2. Dispose of all packaging materials properly.
Tools and Parts
■ Gather the required tools and parts before starting assembly.
■ Read entire manual before starting assembly.
Tools Needed
■ 1/2" Socket Wrench
■ 1/2" Open end Wrench
Tools Supplied
■ 5/16" Hex key
ASSEMBLY INSTRUCTIONS
IMPORTANT: Determine whether you will be mounting the shelf to the wall with the braces above or below the shelf.
A
A
2. Mounting braces above shelf
With the braces pointing downward, align the braces with the
center and back holes on the each side of the shelf.
Use 5/16" Hex head bolts (F1) and 5/16" Flange nuts (F2) to
attach a brace to each side of the shelf. Fully tighten the bolts.
A. Brace attached to the Shelf
A. Brace attached to the Shelf
With the braces pointing upward, align the braces with the
center and back holes on the each side of the shelf.
Use 5/16" Hex head bolts (F1) and 5/16" Flange nuts (F2) to
attach a brace to each side of the shelf. Fully tighten the bolts.
1. Mounting braces below shelf