Installation guide

INSTALLATIONINSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
IMPORTANT: Decide if you are going to mount the cabinet on
GladiatoP _GearWaIP panels or GearTrack TM channels, or on a
standard wall.
n C(xbi st ! P(xne s
Gec N i'(: ck Chc nne s
IMPORTANT:
• Be sure the GearWall _ panels or GearTrack TM channels are
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
• If installing cabinet on GearTrack TM channel, a second channel
should be installed 18" below the bottom of the supporting
channel so the cabinet will hang level.
Attach Mounting Bracket
F7 F8 F2
F7 Carriage-head bolt (2) F2 _/' Flange nut (2)
F8 Washer (2)
1. With the mounting bracket (P9) rims pointing down, align the two
bracket holes with the two holes in the top back
panel (P4).
2. Working from the back, insert a carriage bolt (F7) through the
bracket and top back panel (P4).
3. Working from the cabinet interior, fasten each bolt with a
washer (F8) and a flange nut (F2). Fully tighten the bolts.
4. Close the cabinet doors.
Mount on GearWall _ Panels or GearTrack TM Channels
1. Determine cabinet mounting location on GearWall ® panels or
GearTrack TM channels.
2. Using two or more people, engage the mounting bracket into the
wall slots by lifting up, pushing toward the wall and lowering the
bracket rims into the slots.
3. Inspect the cabinet from the sides to ensure the wall-mounting
bracket is fully engaged slots as shown.
A
B
A. Bracket rim C. Mounting bracket
B. Slot fully engaged
Tools and Parts Needed: V2" Wrench, sad' x 11_2"Lag screws (4), 5/_6"
Flat washers (4)
IMPORTANT: The round holes in the top and bottom cabinet back
panels are spaced to allow you to mount the wall cabinet to your
garage wall studs.
1. Locate the wood studs in your garage wall. Align two holes at the
top and two holes at the bottom with the wood studs, and mark
the location of the holes.
2. While two or more people hold the cabinet against the wall,
attach the wall cabinet to the garage wall using sad' flat washers
and 5A?' x 11_2"Lag screws (not provided).
3. Using a _2" wrench, fully tighten the screws.
P5
A. Bracket rims pointing down
A
A. Holes for standard wall mounting