FREEZEP.ATOR TMFREEZER FREEZERATOR TMCONGELADOR FREEZERATOR TM CONGI_LAIEUR Table of Contents/[ndice/Table des matieres ............ 2 THE EL LE BEST MEJOR MEILLEUR GARAGE ON THE GARAGE DE LA GARAGE DU BLOCK. CUADRA. QUARTIER.
TABLEOF CON'ENIS FREEZER SAFETY ......................................................................... INSTALLATION INSTRUCTIONS .................................................. 3 4 Unpacking .................................................................................... 4 Location Requirements ................................................................ 4 Electrical Requirements ...............................................................
FREEZERSAFEW Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. All willsymbol. follow the safety alert symbol and either the word "DANGER" or Thissafety is themessages safety alert "WARNING.
INSTALLATION INSIRUCTIONS NOTE: Do not install the freezer near an oven, radiator, or other heat source where the temperature will rise above 110°F (43° C), nor in a location where the temperature will fall below 0°F (-17 ° C). Removing packaging materials • Remove tape and glue residue from surfaces before turning on the freezer. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
Cabinet 1. TOOLS NEEDED: %6 in. hex-head socket wrench, #2 Phillips screwdriver, flat-blade screwdriver, %6 in. open-end wrench, flat 2 in. putty knife. IMPORTANT: • Before you begin, turn the lower compartment unplug freezer or disconnect power. control OFF, • Remove food and any adjustable door or utility bins from doors. If you are only removing and replacing the doors, the instructions are the same regardless of door style.
I .... F 1. Bottom Hinge Hole Plug Top Hinge I CabinetHinge I I l Hole Plugs [] _" °'=\1 1. Door Hinge Hole Plug I Top Hinge Cover 2 %6" Hex-Head Hinge Screws 3. Top Hinge I iiii Ceo,o,.inge Removal of Door Stops ' l! 1 Door Stop 2. Door Stop Screw Reinstallation of Door Stops Bottom Hinge ! Door Stoo 2 Door Ston ScreH 2 !.
¸i̧ii¸i̧iii :i!!ii :iii :::::: ¸ iiiiiiii :::iiiiiiii ::; i NOTE: If you have the casters installed on your freezer, the leveling screws will not work. Shims can be placed under the casters to level a freezer that has casters installed. Door Closing Your freezer has two front adjustable rollers - one on the right and one on the left. If your freezer seems unsteady or you want the doors to close easier, adjust the freezer's tilt using the instructions below: 1. Plug into a grounded 3 prong outlet. 2. 3.
upwards during theentire casterinstallation. Lower Front Corner 1. Leveling bolt (do not remove) 2. Unit bolt 1. Top Hinge 2. Center Hinge 6. Remove the casters and fasteners from the box. 7. Locate and remove the caster brackets from the FeaturePak. 8. Using 5/_e-18x 7/8in. hex-head bolts, attach 1 rigid caster and 1 swivel caster to each caster bracket. The rigid caster fits the front of the bracket and the swivel caster fits on the rear. 9.
Complete the Assembly 1. Lock the front caster wheels. 2. Insert a small piece of cardboard between the caster brake and the floor. This will help prevent the brake from rubbing on the floor. • You may hear water running into the drain pan during the defrost cycle.
To change the upper compartment to Freeze mode: • Turn the control all the way to FREEZE. Freeze Freeze I If you need to adjust temperatures, use the settings listed in the chart below as a guide. Wait at least 24 hours between adjustments and then recheck the temperatures. I Coldest # Coldest Lower Compartment Control The lower compartment functions as a freezer at all times.
To remove and replace the upper compartment floor: There are two half-width wire baskets in your freezer. To remove and replace a half-width basket: f. Remove all items from the compartment 2. 3. Remove the floor by raising the front and lifting it out. Replace the floor by inserting the two rear tabs into the holes in the rear of the lower compartment. Lower the floor onto the liner of the lower compartment. ::::: : :::: ::: :::: : floor. 1. Remove all items from basket.
To remove and replace the shelf: To remove and replace the bins: 1. Remove all items from the shelf. Remove the shelf by raising the front and pulling it forward. 2. 1. Remove the bin by lifting it and pulling it straight out. 2. Replacethebinbyslidingitinabovethedesiredsupportand pushing it down until it stops. Replace the shelf by lifting the front while sliding the shelf back until it locks into place. r..__ To remove and replace the wire door shelf: 1.
FREEZER CARE = = NOTE: Not all bulbs will fit your freezer. Be sure to replace the bulb with one of the same size, shape, and wattage. 1. Unplug freezer or disconnect power. 2. Remove the bulb from behind the control panel in the lower compartment or from behind the light shield in the upper compartment (on some models). Replace it with a bulb of the same wattage. 3. Plug in freezer or reconnect power. Explosion Hazard Use nonflammable cleaner.
4. Empty waterfromthedefrost pan. 5. Clean, wipe,anddrythoroughly. 6. Takeoutallremovable parts,wrapthemwell,andtapethem together sotheydon'tshiftandrattleduring themove. 7. Unlock the casters so that the freezer rolls easily. 8. If you have not installed the casters, raise the front of the freezer so it rolls more easily. See the "Door Closing and Alignment" section. g. • Are the doors closed completely? Close the doors firmly.
For further The doors will not close completely • Are food packages blocking the door open? Rearrange containers so that they fit more tightly. TM Are the crisper cover, pans, shelves, bins, or baskets out of position? Put these items into their correct positions, See the "Lower Compartment Features" section for more information. • Are the gaskets sticking? Clean gaskets and the surface that they touch. Rub a thin coat of paraffin wax on the gaskets following cleaning.
GLADIATOR"GARAGEWORKS FREEZERATOR'" FREEZER WARRANTY ONE-YEAR FULL WARRANTY For one year from the date of purchase, when this freezer is operated and maintained according to instructions attached to or furnished with the product, Gladiator TM GarageWorks will pay for FSP® replacement parLs and repair labor costs to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company.
