Installation Guide

Use and Care Guide
Vanity Combo
3
INSTALLING THE CABINET
For wall stud installation, insert #12 x 3 in. screws with washers into the stud locations (not included).
For drywall installation, drill holes at the appropriate locations and insert toggle bolts with washers (not included).
For concrete wall installation, drill 1/4 in. holes at the appropriate locations and insert #12 wall anchors, followed
by #12 x 3 in. screws (not included).
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts are present.
Compare parts with the Hardware Included list. If any part is
missing or damaged, do not attempt to install the product.
Determine the desired mounting location, and mark the
wall where the unit will be installed.
NOTE: For secure installation, the unit must be mounted to
at least one wall stud.
2
POSITIONING THE CABINET
Move the cabinet into place, and use wood
shims to level the cabinet against the wall.
Item #1000 019 065
Model #PPTDACO24
TOOLS REQUIRED
Claw hammer Safety goggles Phillips screwdriver Power drill
Measuring tape Wall hardware Caulk/sealant Level
4
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumbers putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer’s instructions.
Apply silicone caulk/sealant (not included) to all four corners of the cabinet.
Place the vanity top onto the cabinet.
Position the top so that it has an equal amount of overhang on each side and use a level to ensure the vanity top surface is level.
Apply silicone onto the seam between the edge of the vanity top and the wall, smooth the bead, and allow to cure before use.
5
REMOVING THE DRAWER
Press
upward
Press
downward
Press release levers in opposite directions while pulling
drawer out of the cabinet.
HARDWARE INCLUDED
AA - Handle x 3
BB - Short
Screw x 4
CC - Long
Screw x 2
HOMEDEPOT.COM
Please contact 1-888-774-8062 for further assistance.

Summary of content (4 pages)