Installation Guide

3
INSTALLING THE CABINET
□ For wall stud installation, insert #12 x 3 in. screws with washers into the stud locations (not included).
□ For drywall installation, drill holes at the appropriate locations and insert toggle bolts with washers
(not included).
□ For concrete wall installation, drill 1/4 in. holes at the appropriate locations and insert #12 wall anchors,
followed by #12 x 3 in. screws (not included).
Installation
1
PREPARING FOR INSTALLATION
NOTE: Before installation, make sure all parts are present.
Compare parts with the Hardware Included list. If any part is
missing or damaged, do not attempt to install the product.
□ Determine the desired mounting location, and mark the
wall where the unit will be installed.
NOTE: For secure installation, the unit must be mounted
to at least one wall stud.
2
POSITIONING THE CABINET
□ Move the cabinet into place, and use wood
shims to level the cabinet against the wall.
4
INSTALLING THE VANITY TOP
IMPORTANT: Do not use plumber’s putty.
NOTE: The faucet, drain, and supply lines are not included. Install these
parts to the vanity top according to the manufacturer’s instructions.
□ Apply silicone caulk/sealant (not included) to all four corners of the cabinet.
□ Place the vanity top onto the cabinet.
□ Position the top so that it has an equal amount of overhang on each side and use a level to
ensure the vanity top surface is level.
□ Apply silicone onto the seam between the edge of the vanity top and the wall, smooth the
bead, and allow to cure before use.
Use and Care Guide
Vanity Combo
TOOLS REQUIRED
Claw hammer Safety goggles Phillips screwdriver Power drill
Measuring tape Wall hardware Caulk/sealant Level
HARDWARE INCLUDED
AA - Knob BB - Knob Screw
18" x 1 x 1
24" x 2 x 2
Item #
1000 959 159
Item #
1000 877 814
Item #
1000 013 647
Model #
PPMELCHT18
Model #
PPMELCHT24
Model #
PPMDACO24
HOMEDEPOT.COM
Please contact 1-888-774-8062 for further assistance.